Item No.:1:10 Nitro on road nitro rc racing car model similar 94122

Description: nitro rc racing car model

AM27 transmitter with LED Screen, 1800ham battery

Speed: 70-80 KM / hour

Play time: 15 minutes

Engine level:15cxp, 18cxp

Power: gas

4pcs/carton

Item size: 43*20*13.5 cm

Carton size: 67*30*20cm

Packing size: 70*45*64 cm

G.W/N.W: 22.4/19.5kg

Specification:

* 2 Speed Automatic Transmissuion.
* Powerful 15 engine equipped with slide carburetor and pull-starter.
* Four wheel drive system with shaft drive.
* Front/rear differentials with good quality bevel gears easy for maintenance.
* The mode of professional screw thread adjustable hydraulic pressure shock absorber.
* 3mm Aluminum alloy chassis.
* Solid universal joint cup/high performance ball bearings complete.
* Positioning independence adjustable full wheel.
* Antiskid and abrasion proof rubber ture
* 3 Channels liquid crystal numeral shown controller.
* Differential box comesw with high strength and abrasion proof alloy steel gear.
* Including tools and english manuals of the car and the transmitter. 

Function:

Go forward&reverse, turn left&right, 4x4 full time drifting

Dimensions of vehicle:
Length: 367mm
Height: 105mm
Width: 200mm
Track: 174mm
Wheelbase: 258mm
Tyres: 68 x 27mm
Ground clearance: 8mm
Gear ratio: 6.35: 1
Weight: 1850g 

Packing:

-HL Lightning Brushless Version 1/10th scale road car
-3 Channel LCD screen Computerized Radio Transmitter
-User Manuals.
-7.2V,1800mAh battery
4pcs/carton

Item size: 43*20*13.5 cm

Carton size: 67*30*20cm

Packing size: 70*45*64 cm

G.W/N.W: 22.4/19.5kg

Features:

1) the process of cleaning before driving your car: For cleaning the engine,1-2 tank oil's use is a standard, and then run your car slowly to run out of another 1-2 tank oil, all ways down, the cleaning work is over, the car can run normally

2) turning on the transmitter and the receiver: Extend the antenna of the transmitter and the receiver, and then switch on the transmitter and the receiver in succession;

While switching on the receiver, make sure the carburetor is at the neutral position

3) fill the fuel: Fill the special model's fuel, and mix the gas and the lubricating oil, the rate of the gas to the lubricating oil is 25:1; close the fuel tank's cover and fasten it after it after filling the fuel

4) starting the engine: Push the front valve several times until securely streaming out oil; shut down the wind gate, and turn the accelerograph to the position that

Spaces 1/4-1/3 place of opening; pull the pulling-start rod until engine send out sound of start to start engine adjust the wind gate to the place which spaces 1/4 position of opening position; pull the pulling-started rod quickly; start engine several minutes to pre-warm

5) stop the engine: The engine will immediately stop running as long as you press the stall switch of the engine, please refer to the instruction manual(g230 rc) for more details

6) 2-channel transmitter system: The servo must be set at the center position before installation, to set the neutral turn on the transmitter and receiver, set the trim tabs in the center position, and turn off the receiver and transmitter in succession, the

Servo will be in the proper neutral position for installation

 

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: